New crate motor install all and all they did a great job just wish they tighten up and installed some bolts . Only have been broken down twice since the install.

This place is terrible, I had an n14 rebuilt by them 5 years ago, I've spent close to 10k in 5 years fixing leaks, these ignorant monkeys used silicone everywhere, they were too cheap to replace gaskets, prongs. Stay away. Terrible shop 😂

Hello. I bought a Remanned Cummins N14 Celect Plus from this shop February 23rd, 2022. I had the motor installed March 10th by a local shop. Was told the engine was put through a test run to make sure it ran before it showed up to me. Once we installed said engine, could not get it to start. Turned out, the fuel pump wasn’t even close to good enough psi wise to start the engine. The part number on the fuel pump wasn’t even a Cummins part number. Swapped the fuel pump with the one I had on the engine I ended up sending them and the engine started right away. Engine was fine at first, then shortly after first break in oil change at 5,000 miles, the motor started to have a flutter. Bad enough it almost would shut the motor down. I took it to my local Truck Center Companies shop, come to find out a pig tail near one of the injectors was causing the problem. It was fixed at my expense along with replacing the new water pump that came with this engine. That was completed May 10th. Not even 3 weeks later, I’m cruising down the road and the motor breaks. Upon inspection, there is now a hole in the block at approximately 17,000 miles. And I’m being told I have to pull the motor and send it to them then I MIGHT get warranty on it. Even though an April 28th shows the ecm download with no codes, they have that, repair orders, pics of the speedometer for miles and the current ecm download showing the codes it’s showing now. This is absolutely crazy!!